Removing A 3.5-Inch Drive From A Drive Bay - HP 6200 Pro Microtower Series Hardware Reference Manual

14. Rotate the drive cage back down to its normal position.
CAUTION:
Figure 4-27
15. Replace the front bezel (if removed) and access panel.
16. If the computer was on a stand, replace the stand.
17. Reconnect the power cord and turn on the computer.
18. Lock any security devices that were disengaged when the access panel was removed.

Removing a 3.5-inch Drive from a Drive Bay

CAUTION:
computer.
The 3.5-inch drive is located underneath the 5.25-inch drive. You must remove the 5.25-inch drive
before removing the 3.5-inch drive.
1. Follow the procedure in
the 5.25-inch drive and access the 3.5-inch drive.
CAUTION:
from the electrical outlet before proceeding.
ENWW
Be careful not to pinch any cables or wires when rotating the drive cage down.
Rotating the Drive Cage Down
All removable media should be taken out of a drive before removing the drive from the
Removing a 5.25-inch Drive from a Drive Bay on page 110
Ensure that the computer is turned off and that the power cord is disconnected
to remove
Installing and Removing Drives 115