Table of Contents
Advertisement
9.
Connect the power and data cables to the drive as indicated in the following illustrations.
a.
If you are installing an optical drive, connect the power cable (1) and data cable (2) to the
back of the drive.
NOTE:
the system board to the rear of the optical drive bays.
Figure 2-23
b.
If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA.
Figure 2-24
10.
If you are installing a new drive, connect the opposite end of the data cable to the appropriate
system board connector.
NOTE:
drive to the white SATA connector on the system board labeled SATA2. Connect the data cable
for a second optical drive to the white SATA connector on the system board labeled SATA3.
Refer to
connectors.
40
Chapter 2 Convertible Minitower (CMT) Hardware Upgrades
The power cable for the optical drives is a two-headed cable that is routed from
Connecting the Optical Drive Cables
Connecting the Media Card Reader USB Cable
If you are installing a new SATA optical drive, connect the data cable for the first optical
System Board Connections on page 23
for an illustration of the system board drive
ENWW
- Quick Links:
- Standard Configuration Features
Hide quick links:
Advertisement
Table of Contents
