Maintenance/Parts Replacement; Replacement - Enerzone SOLUTION 1.7 Owner's Manual

7. Maintenance/Parts Replacement

7.1

Replacement

The glass used is a ceramic glass, 5/32" (4 mm) thick, 16 3/4" W X 9 1/16" H X 10 13/16" H (425
mm W x 230 mm H x 275 mm H), tested to reach temperatures up to 1400º F. If the glass breaks,
it must be replaced by a ceramic glass from SCHOTT with the same specification. Contact your
dealer to obtain a genuine replacement part.
WARNING : DO NOT USE SUBSTITUTE MATERIALS WHEN REPLACING THE GLASS.
To remove or replace the glass (D):
1. Remove the door (E) from its hinges and lay it on a soft, flat surface.
2. Remove the eight screws (A), the eight glass retainers (B), and the metal frames (C).
3. Remove the glass (D). If it is damaged install a new one in place. The replacement glass must
have a gasket all around (see procedure below).
4. Reinstall the glass, being careful to centre the glass in the door and not to over-tightening the
retaining screw.
The two main causes of broken door glass are uneven placement in the door and over-tightening
the retaining screws.
Installation and Operation Requirements - Solution 1.7
Do not clean the glass when the stove is hot.
Do not abuse the glass door by striking or slamming shut.
Do not use the stove if the glass is broken.
Page 43