Nilfisk-ALTO MC 5M Operating Instructions Manual page 19

5.2.3 Buildings and Equipment
Task
General surfaces Foam injectors
Standard lance
Metallic equipment Curved lances
Tank cleaning
head
Detergents Intensive
J25 Multi
Combi Aktive
Alkafoam
Disinfectant
DES 3000
Rusted or Wet Sandblasting
damages surfaces equipment
prior to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in as-
sociation with accessories and detergents. Each cleaning task is different. Please consult your local
dealer or Nilfi sk-ALTO representative in order to discuss the best solution for your own cleaning tasks.
Options / model variants
1)
Original instructions
Accessories
1. Apply thick foam over the surfaces to be cleaned.
Apply on dry surfaces. Apply from top to bottom on
vertical surfaces. Let the foam act for up to 10 - 30
minutes for the optimal effect.
2. Proceed with cleaning using the high pressure
lance. Use applicable accessories. Use high
pressure to dislodge large amounts of incrusted
dirt or grime. Use lower pressure and high water
volume in order to rapidly flush away loose dirt and
rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces are
perfectly clean.
Areas covered by amounts of loose dirt, such as
animal remains in slaughterhouses, can be removed
by using high water flow to flush away the dirt to
evacuation pits or drains.
Tank cleaning heads can be used to clean barrels,
vats, mixing tanks etc. Cleaning heads may be
hydraulically or electrically powered and give the
possibility for automatic cleaning without a constant
user.
1. Connect the sandblasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during
sandblasting.
3. Spray the surfaces to be treated with the mix of
water and sand. Rust, paint etc will be stripped off.
Method
MC 5M, MC 6P, MC 7P
19