Table of Contents
Advertisement
8. Tighten four #8 x 3/4" Screws (2) into the left and
right handrail assemblies (E, G) and into the Left
and Right Uprights (89, 90).
9. Set the Console Base (64) face down on a soft
surface to avoid scratching the Console Base.
If there are ties (H) securing the Pulse Crossbar
(93) to the Console Base, remove the ties.
Remove and discard the four indicated screws
(I). Then, remove the Pulse Crossbar (93).
Next, remove and save the four 5/16" x 3/4"
Screws (4) and the six #8 x 3/4" Screws (2).
Then, lift out the two Console Clamps (92) and
the Console Frame (18). Note: There may be
Console Ground Wires (58) connected to the
Console Frame. Raise the Console Frame far
enough to disconnect the Ground Wires.
8
E
2
89
9
2
18
4
H
93
11
2
G
90
64
2
2
58
I
92
4
H
2
Advertisement
Table of Contents
