Table of Contents
Advertisement
4.6
CO Line Programming
Description
Selection
Default
Programming
Conditions
Feature References
Intercept Extension — Day / Night
Intercept Routing provides an automatic re-direction of calls which
cannot or have not been answered. These programs set the
destination in both day and night modes for each line group.
• CO line group (TRG) number: 1 through 8,
• Extension number: 2 through 4 digits / Disable (no Intercept
All CO line groups – Disable — Day / Night
1.
Enter a program address (409 for day or 410 for night).
Display example: TRG Intercpt Day
2.
Press NEXT.
Display: TRK GRP NO?–>
3.
Enter the CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1:Disable
4.
Enter an extension number.
To change the current entry, press CLEAR and the new number.
To disable Intercept Routing, press CLEAR.
5.
Press STORE.
6.
To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
7.
Repeat steps 4 through 6.
8.
Press END.
• You set the extension numbers in program [003] "Extension Number
Set" or floating numbers of pagers in program [813] "Floating Number
Assignment." You cannot assign the floating number of the modem.
• To assign all CO line groups to one selection, press the
In this case, the display shows the contents programmed for CO line
group 1.
• Program [401] "CO Line Group Assignment" is used to assign each CO
line to a CO line group.
Section 3, Features,
Intercept Routing
( =all CO line groups)
Routing)
System Programming
409-410
key at step 3.
4-89
Advertisement
Table of Contents
