Table of Contents
Advertisement
SECONDARY AIR TUBES REPLACEMENT
(Replacing secondary air tubes)
COLD STOVE
1.
Unplug heater from 115V AC outlet.
2.
Put drop cloth down.
3.
Empty ashes.
4.
Remove air tubes. The (3) secondary air tubes are located in top of burn chamber. (NOTE, front/rear air tubes have 24 holes per tube,
middle air tube has 12 holes per tube) On right side of tubes you will find a cotter pin. To remove air tube remove cotter pin and slide
tube to left, it will drop down, slide tube to right it should come out. (See Figure Below).
5.
Replace air tube. On one end of tube you will find a hole drilled on both sides through the tube. This end goes to right side. Place tube
in left tube holder and slide other end of tube into right side tube holder. Line up through hole in air tube with tube holder bracket and
replace cotter pin and bend slightly so it wont fall out.
COTTER PIN
TUBE HOLDER BRACKET
SECONDARY AIR TUBES FRONT/REAR
PS210026 - 24 HOLES PER TUBE
(Replacing baffle board)
COLD STOVE
1.
Unplug heater from 115V AC outlet.
2.
Put drop cloth down and empty ashes.
3.
Repeat steps 1-5 from above removing 1st tube only.
4.
The baffle boards run long ways front to rear. Lift and slide baffle board toward the front. (See Figure Above).
5.
Replace baffle board making sure the board is seated on top of air tubes and behind front baffle board holder. After replacing both
baffle boards replace front air tube following step 5 from secondary air tube replacement.
MAINTENANCE
BAFFLE BOARD BOTTOM POBPFB01
19 X 9 1/2
BAFFLE BOARDS REPLACEMENT
INSULATION BOARD TOP POBPFB21
11 X 13 1/8
Figure 32
Page 44
SECONDARY AIR TUBE MIDDLE
PS210030 - 12 HOLES PER TUBE
TUBE HOLDER
Advertisement
Table of Contents
