Section Iv: Residential Freestanding Installation; Out Side Air Installation - BuckMaster 21 Operation Maintenance Saferty

RESIDENTIAL FREESTANDING INSTALLATION
TOOLS FOR INSTALLATION
Drop cloth, 3/32" Metal drill bit, 5/16" magnetic socket chuck adapter, 5/16" wrench (box or socket) or adjustable
wrench, Jigsaw with masonry, metal and wood blades
WARNING: DO NOT INSTALL IN A SLEEPING ROOM
PREPARING THE STOVE FOR INSTALLATION
1. Remove the protective plastic wrapping from the unit, inspect the unit for any obvious physical damage.
2. Plug the power cord into a 115V AC outlet to test the motor and fan when optional motor is being used. "Do not
run power cord under unit or in high traffic areas".
3. Check the primary air draft control to ensure that it slides freely.(See Figure 5).
4. Remove any items from within the firebox. Spread a dropcloth on the floor behind the heater. Next, tilt the
heater so that the back is on the drop cloth.
5. ( Leg Kit ): If legs are to be used, obtain four legs, attach the legs to holes in bottom of unit with bolts and
washers supplied with the leg kit. (See Figure 5).
6. ( Pedestal Kit ): If pedestal kit is being used (and out side air is required see below, Out Side Air
Installation). Open freestanding kit and obtain the stand. Place the stand against bottom of the heater (angle side
to heater). Center stand front to rear and also center stand left and Right. Mark screw locations on bottom of
stove through outer holes of stand mounting angles. Set stand aside and drill four 7/32" holes in heater bottom.
Before attaching heater to the stand, take a large flat screwdriver or pliers and remove the 2" x 2" knockout on
bottom of unit.
(See Figure 5A). Then mount stand to bottom of heater with screws provided. (See Figure 5A).
7. Obtain four (4) 3/16" self-tapping screws and secure the stand to the heater.
8. Reposition the heater to the upright position.
PRIMARY AIR
DRAFT CONTROL
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR MUST BE MAINTAINED. (MOVE
OPENING AND/OR REPOSITION HEATER LOCATION IFNECESSARY).
1. Select an installation location that gives the best airflow from the front of the heater to the remainder of the home.
2. Place the protective floor pad in position. For minim floor protection (See Page 14).
SECTION IV
HOLES FOR MOUNTING PEDESTAL
Figure 5A
Figure 5

Out Side Air Installation

CAUTION
Page 12
2" x 2"
KNOCKOUT
PEDESTAL