Appliance Cleaning - ARIETE Miro 1339B Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 11
in the steam waiting phase small puffs of steam may be released from the flange of the filter holder, this phenome-
non is perfectly normal.
Press and hold the steam dispensing button (K): first a bit of water will come out and immediately after a steam jet whose
intensity increases within a few seconds. Release the steam dispensing button to stop the steam spurt. Place the milk contai-
ner to mount (or liquid to be heated) under the Maxi Cappuccino device (G). Immerse deeply the stylus into the milk jug (Fig.
13) and press again the button (K) until you obtain the desired result. During these operations, you will see that the boiler
temperature indicator light of the switch (M) turns on and off periodically, indicating the action of the thermostat which main-
tains the proper temperature of the boiler for steam dispensing. Release the steam dispensing button to stop the steam spurt.
it is opportune you start dispensing the steam only when this indicator lamp (m) is on. dispense the steam for a
few seconds after every use in order to free the hole of any milk residue.
useful TIps fOr preApArIng A gOOD ITAlIAn espressO
The ground coffee in the filter holder has to be pressed lightly. Whether the coffee is stronger or weaker depends on the
degree the coffee is ground, the quantity put into the filter holder and the pressing. Just a few seconds are needed for the
coffee to flow down into the cups. If the dispensing time is longer, this means that the coffee is ground too fine or that the
coffee put into the filter holder has been pressed too much.
hOW TO MAke TeA AnD InfusIOns
After performing the operations described in the "Preliminary steps for use" chapter, place a cup underneath the Maxi Cap-
puccino wand (G). Press the coffee brew button (L). Press and hold the steam dispensing button (K); in this way hot water
will come out of the Maxi Cappuccino device. The maximum quantity for two cups is 200 ml.

ApplIAnce cleAnIng

Warning!
All cleaning operations described below must be performed with the machine off and with the electric plug discon-
nected from the socket-outlet.
Warning!
Regular maintenance and cleaning preserve and keep the machine efficient for a longer amount of time. Never
wash machine components in the dishwasher. Do not use direct jets of water.
Warning!
All operations must be performed when the machine is cold.
cleaning the filter containing the grounds
Check that the holes are not clogged and if so, clean them with a small brush (Fig. 14). Dispense boiling water from the filter
holder with the filter inside, without coffee grounds, after placing a glass underneath the dispenser in order to dissolve or
remove any coffee residue or impurities.
Warning!
Slowly remove and disconnect the filter holder because any remaining pressure could cause splashes or squirts.
It is advisable to thoroughly clean the filter (A) about every 3 months using Ariete COFFEE CLEAN detergent tabs, which
can be found at retail stores and the Authorised Service Centres, following the instructions inside the package. As an
alternative, you:
• Put a dishwasher detergent tab into the filter (without coffee) when the machine is hot (after heating for at least five minu-
tes).
• Couple the filter holder to the machine and put a container underneath the filter holder.
• Press and hold the steam dispensing button (K). Wait until water flows out of the filter holder seat (Fig. 5). Dispense water
for 15-20 seconds.
• Release the steam dispensing button to stop the flow of water. Let the tablet work for at least 15 minutes, keeping the filter
holder inserted on the machine.
• Repeat the water dispensing operation by operating the pump for about 15-20 seconds, and then letting it rest for another
15-20 seconds, until two tanks of water are used up.
• Remove the filter holder from the machine, remove the filter and rinse it well under running tap water.
• Turn off the machine, disconnect the power cable from the socket-outlet and clean the coupling seat of the filter holder
with a sponge in order to remove any detergent residue from the shower disc.
16

Advertisement

Table of Contents
loading

Table of Contents