Additional Data - Siemens SINUMERIK 840D sl Operating Manual

Multiple load points
If you have configured several loading points for a magazine, then the "Select loading point"
window appears when a tool is created directly in an empty magazine location or when the
"Load" softkey is pressed.
Select the required load point and confirm with the "OK" softkey.

Additional data

If configured accordingly, the "New tool" window opens after the required tool has been
selected and confirmed with "OK".
You can define the following data in this window:
● Names
● Tool location type
● Size of tool
References:
For a description of configuration options, refer to the
Commissioning Manual SINUMERIK Operate / SINUMERIK 840D sl
8.5.3 Additional data
The following tool types require geometry data that is not included in the tool list display.
Tools with additional geometry data
Tool type
111 Conical ballhead cutter
121 End mill with corner
rounding
130 Angle head cutter
131 Angle head cutter with
corner rounding
Universal
Operating Manual, 03/2013, 6FC5398-6AP40-3BA1
Additional parameters
Corner radius
Corner radius
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
Geometry length (length X, length Y, length Z)
Corner radius
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
Tool management
8.5 Tool list
195