Gas Connection - Inalto ICGG302W User Manual

(A) SEALING STRIP

Gas Connection

(C) SCREW
(B) BRACKET
WARNING:
• This appliance must be installed and
Gas Connection
connected in accordance with installation
regulations in force in the country in which
the appliance is to be used.
• This appliance is supplied to run on LPG
This appliance must be installed and connected in accordance with installation
and natural gas. Conversion for use on LPG
regulations in force in the country in which the appliance is to be used.
and natural gases must only be undertaken
by a qualified person.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG
and natural gases must only be undertaken by a qualified person.
INSTALLATION OF APPLIANCE
Installation of appliance
Note: Wear protective gloves to fit the hob.
Note: Wear protective gloves to
fit the hob.
CAUTION!
lf it is necessary to adjust or install the elbow,
it is allowed only torque wrench with 9±1N.m,
and work on the Black nut of manifold instead
of on the elbow.
•
appliance from the aperture in future,
particularly if it needs to be serviced.
Place the bracket (B) over the holes that match the
size of the screws.There are one set of screw holes in
each corner of the hob (H).Slightly tighten a screw (C)
through the bracket (B) so that the bracket is attached
to the hob, but so that you can still adjust the position.
2. Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
On the underneath of the hob, adjust the brackets into
3.
a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into
ADJUSTING THE DIRECTION OF ELBOW
position.
After loosening the elbow, adjust the elbow
interface to the required direction as required,
and keep the hexagonal head of the elbow
Elbow
motionless with a wrench. Use a 9±1N.m
torque wrench to tighten the black bolt of the
gas inlet pipe assembly. Ensure that the torque
of the wrench is within the required range to
prevent elbow breakage or damage caused
by excessive force. After the installation is
tightened, check whether the parts are in
good condition and test the air tightness to
ensure the tightness of the installation. The
Torque:
Black nut of
9±1N.m
installer is responsible for the results of
manifold
the process.
CAUTION: DANGER OF LEAKS!
If any connection is handled, check the seal.
16
The manufacturer is not liable for any
connection leaking, after being handled.
18
Caution!
lf necessary to adjust or
install the elbow, it is allowed
only torque wrench with
9±1N.m, and work on the
Black nut of manifold instead
of on the elbow.