Inalto ICGG302W User Manual page 17

Figure 6
(A) SEALING STRIP
(A) SEALING STRIP
(C) SCREW
(C) SCREW
(B) CLAMP
(B) BRACKET
17
Do not use a silicon sealant
appliance against the apertu
FITTING THE CLAMPS
of the screws.There are one set of sc
• Ensure that the hob is free from all burner
corner of the hob (H) .
pieces and trivets. Place the hob upside
down on a soft surface to protect both the
Slightly tighten a screw (C) through t
hob and your worksurface from damage.
that the bracket is attached to the ho
• Place the bracket (B) over the holes that
match the size of the screws. There are one
can still adjust the position .
set of screw holes in each corner of the
hob. Slightly tighten a screw (C) through
. 2 Carefully turn the hob back over and
the bracket (B) so that the bracket is
it into the aperture hole that you have
attached to the hob whilst still allowing you
to adjust it's position.
. 3 On the underneath of the hob, adjus
• Carefully turn the hob back over and then
gently lower it into the aperture hole that
a position that is suitable for your wor
you have cut-out in your benchtop.
• On the underside of the hob, adjust the Then fully tighten the screws (C) to s
brackets into a position that is suitable
position.
for your benchtop. Then fully tighten the
screws (C) to secure the hob into position.
17