Advertisement
Vision– Desk ADJUSTABLE HEIGHT
Install Instructions
Tools Required
•
5MM Allen Wrench
•
Tape Measure
•
Screw Driver
•
Level (Minimum 4' )
Hardware Included
•
(6) Min-fix Cams and Post
•
(16) #10 X 7/8 Pan Head Phillips
•
(6) #8 X 5/8 Pan Head Philips
•
40" Wire manager (Protum)
•
Hardware Bag
•
(4) U-Brackets
Installation
BENCH HEIGHT OPEN STORAGE
8/26/2022
ADJUSTABLE HEIGHT PEDESTAL
RIGHT DESK UNIT SHOWN LEFT OPPOSITE
Form No. INST-VS0029
Figure A
RIGHT UNIT SHOWN LEFT IS OPPOSITE
(NOTE: 18" DEEP UNITS HAVE NO SHELF)
Figure B
DESK TOP
(2) TOP STIFFENERS
MODESTY PANEL
1
Advertisement
Table of Contents
Related Manuals for JSI Vision-Desk ADJUSTABLE HEIGHT
Summary of Contents for JSI Vision-Desk ADJUSTABLE HEIGHT
- Page 1 Vision– Desk ADJUSTABLE HEIGHT Install Instructions Figure A Tools Required • 5MM Allen Wrench • Tape Measure • Screw Driver • Level (Minimum 4’ ) Hardware Included • (6) Min-fix Cams and Post • (16) #10 X 7/8 Pan Head Phillips •...
- Page 2 Installation (Door Panel Removable) Remove outer panel by pulling out. Remove inner panel by sliding panel upward. Figure C KEKU FASTENER (2) PER PANEL (PULL TO RELEASE) OUTSIDE PANEL PULLS/SNAPS OFF MINI RAFIX FASTENER (2) PER PANEL (PULL TO RELEASE) INSIDE PANEL SLIDES UP TO REMOVE KEKU SLIDER FASTENER (4) PER PANEL...
- Page 3 Installation Desk Assembly Position Bench Height Pedestal in place. Slide Top assembly into place , insuring Top Support Rail slide into the Bench Height Leg assembly. Secure Pedestal to to using #10 X 7/8 Pan Head Phillips screws. Lock both sides of Top Support Rails into place using 5mm Allen Wrench. Figure (E) ALLEN HEAD SET SCREW (4) PER TOP SUPPORT RAIL...
- Page 4 Installation (Modesty Panel) Install Mini-fix Cam into Modesty panel with arrow facing to the top edge. Insert Mini-Fix post into Top, using (Table 1-1) to locate post. Turn Mini-Fix cam clockwisw to secure Modesty Panel. Figure (G) MINI-FIX POST (QTY SEE CHART) HOLE SPACING MINI-FIX (ARROW TO TOP EDGE)
Need help?
Do you have a question about the Vision-Desk ADJUSTABLE HEIGHT and is the answer not in the manual?
Questions and answers