Advertisement
Installation Desk Assembly
Position Bench Height Pedestal in place. Slide Top assembly into place , insuring Top Support Rail slide into the Bench Height Leg assembly.
Secure Pedestal to to using #10 X 7/8 Pan Head Phillips screws. Lock both sides of Top Support Rails into place using 5mm Allen Wrench.
#10 X 7/8 PAN HEAD PHILIPS
(4) LEG ASSEMBLY
(2) PER U-BRACKETS (2) U-BRACKETS
Installation (Cabinet)
Attach electrical components to each leg. Connect power cord, leg electrical, and control switch to Control box. Secure Control box between top
support rails. Plug in power cord to source. Must re-set Control box by holding down both the up and down button at the same time till top low-
ers and re-sets. Raise top to allow access to underneath side of top. Secure all electrical wires with the wire clips that are provide in clean and
uncluttered appearance. Reattached Inner Panel (slide down). Reattach Outer Panel (snap in). Wire manager can be position on either pedestal,
to be located vertically above cutout on Pedestals and inside Leg Assembly. Secure both ends.
Note: User discretion to where up/down switch is located.
8/26/2022
ALLEN HEAD SET SCREW
(4) PER TOP SUPPORT RAIL
OUTER PANEL SNAPS ON
CONTROL BOX LOCATED BETWEEN
TOP SUPPORT RAILS
Form No. INST-VS0029
Figure (E)
Figure (F)
INNER PANEL SLIDES DOWN
3
Advertisement
