Table of Contents
Advertisement
Alarm Card
Basecard Options
The Alarm Card basecard options are typically set at the factory to match your network operation.
Check these settings when you first install the unit. You need not repeat the procedure unless you
change your network.
1. Examine the option switch on the Alarm basecard.
2. Refer to
Figure 7-1
3. When you are satisfied that the plug-in options are set correct, install the LIM module in the
shelf as described below.
Alarm Card Installation
The Alarm Card has an insertion and extraction tab on the bottom of the front panel.
1. To install a plug-in module, insert the module into its slot with the GDC logo on top, then slide
it in until it makes contact.
2. Pull down the insertion/extraction tab and firmly push the module in until it seats in the rear
connectors.
3. To remove a plug-in module, pull down the insertion/extraction tab to unseat the module, then
pull on the tab.
7-2
for switch location and
Office Connunications Manager OCM-1000/OCM-2000
Installation & Operation
Table 7-1
for option descriptions.
036R340-000
Issue 16
Advertisement
Table of Contents
