Table of Contents
Advertisement
Scope of this Manual
A GDC Office Communications Manager System (OCM) is factory configured to your network
requirements when ordered from the factory. The OCM-2000 or the OCM-1000 is tested, and ready
to operate after installation. This manual describes the installation and operation of OCM modules,
power supplies, and shelf.
The information contained in this manual has been carefully checked and is believed to be entirely
reliable. This information is intended for installers, service technicians and users and assumes a
working knowledge in the design, planning and management of IP networks.
As General DataComm improves the reliability, function, and design of their products, it is possible
that the information in this document may not be current. Contact General DataComm, your sales
representative or point your browser to http:\\www.gdc.com for the latest information on
this and other General DataComm products.
General DataComm, Inc.
6 Rubber Avenue
Naugatuck, Connecticut 06770 U.S.A.
Tel: 1 203 729-0271
Organization of Chapters
This manual is divided into the following chapters. When using the digital version of this manual,
click on any link (shown in blue text) to jump to that section.
Chapter 1, System Description
Chapter 2, Shelf Installation
Chapter 3, Common Control Module
Chapter 3, Common Control Module
Chapter 5, Data Channel Modules
Chapter 6, Voice Modules (VCMs & DPVs)
Chapter 7, Alarm Card
Appendix A, Glossary of Terms
036R340-000
Issue 16
Toll Free: 1 800 523-1737
Office Connunications Manager OCM-1000/OCM-2000
Installation & Operation
Preface
v
Advertisement
Table of Contents
