Battery Charge From A 12V Socket; 6.1 Control Pannel - HAKO Scrubmaster B8 Instruction Manual

- Lower the selector (5) to release the bat-
tery (6).
- It is possible to leave the battery in the
machine or to remove it, if needed.
- Insert the plug (27) into the socket on the
battery (6) indicated by the "
bol, and then connect the battery charger
(21) to a mains socket.
WARNING:
Check that the mains voltage is compat-
ible with the operating voltage of the bat-
tery charger.
- Charge the battery until the "Green" LED
(28) turns on, then unplug the power sup-
ply cord (29) from the AC power outlet
and the cord (27) from the battery.
NOTE:
For the full recharge of the battery, 2 hours
are necessary for the 10 A battery and 4
hours for the 20 A battery.
Partial recharges are also possible.
5.1.a - Battery charge from a 12V
socket (Fig. 4a - 9)
- Place the machine in the vehicle or van
trunk.
- Lower the selector (5) in order to release
the battery (6).
- It is possible to leave the battery in the
machine or to remove it if needed.
- Insert the plug (27a Fig. 4a) in the battery
(6), then connect it to the battery charger
(35) at a 12V power outlet of the vehicle
or van.
WARNING:
The machine is fitted with a safety device
which prevents its operation with an open
battery compartment.

6.1 CONTROL PANNEL

30) Start-up button
- If pressed for three seconds it actuates
the circuits; the LED (31) turns on indicat-
" sym-
ing the inserted line, the vacuum cleaner
operation LED (32) turns on, the water
supply LED (33a) turns on and one of the
battery status LED (34) turns on.
NOTE:
Dopo 5 minuti che la macchina è inattiva au-
tomaticamente si spegne ed è necessario
ripremere il pulsante (30) per riavviarla.
36) Water supply button
- If this button is pressed, the quantity of
water to be supplied during the cycle until
the end of the supply can be set up, by
passing from one quantity to another, the
quantity is indicated by one of the LEDs
(33);
Led 33a = minimum supply.
Led 33b = average supply.
Led 33c = maximum supply.
Leds 33 turned off = no supply.
NOTE:
The rotation of the brush is enabled by the le-
vers (4) pressed or by the lever (3) pressed.
It is possible to cut off the water supply by
pressing the button (36) until all LEDs (33)
are turned off.
37) Vacuum cleaner button.
- Upon the start-up of the machine, the
vacuum cleaner is set to standard opera-
tion and the LED (32) turns on.
- It is possible to go from a normal opera-
tion to a silent operation until the vacuum
cleaner is turned off by pressing the but-
ton (37).
The lit LED (32) indicates a normal op-
eration.
The lit LED (38) indicates a silent opera-
tion.
The turned off LEDs (32) and (38) indi-
cate the turned off vacuum cleaner.
ENGLISH - 7
(Fig. 10)