Troubleshooting - HAKO Scrubmaster B8 Instruction Manual

PROBLEM
If the levers on the handle
bar are pressed, the ma-
chine does not start.
The brush does not rotate.
Aspirator does not work.
The machine does not dry
well, leaving traces of water
on the floor.
The machine turns off.
No water comes out.
Insufficient floor cleaning.

TROUBLESHOOTING

CAUSE
Low battery (battery version
only).
Plug disconnected (charger
version only).
Levers on the handle bar not
pressed.
Brush rotation enabling but-
ton not pressed.
Brush motor damaged.
Vacuum cleaner turned off.
Intake motor damaged.
Aspirator off.
Obstructed vacuum tubes.
Dirty wiper rubber blades.
Squeegee rubber
worn.
Low battery.
Recovery tank full.
Tank empty.
Filter blocked.
Pump not functioning.
Inadequate brush or deter-
gent.
Brush worn.
ENGLISH - 14
SOLUTION
Check that the battery is
charged.
Connect the plug.
Press the levers.
Press the button.
Replace the engine.
Start the vacuum cleaner by
pressing the corresponding
button.
Replace the turbine.
Start the vacuum cleaner by
pressing the corresponding
button.
Check and
clean the vacuum tubes that
connect the wipers to the re-
covery tank.
Clean the rubber blades of
the wiper.
blades Replace or turn over the
squeegee rubber blades.
Charge battery.
Empty the tank.
Fill the tank.
Clean the filter.
Call the technical support
service.
Use brush or detergents ad-
equate to the type of floor or
dirt to be cleaned.
Replace the brush.
if necessary