Removing And Replacing The Vibrator And Vibrator Grommet - Motorola C25 Series Service Manual

Dual band wireless telephone

Hide thumbs Also See for C25 Series:

Table of Contents

Disassembly

Removing and Replacing the Vibrator and Vibrator Grommet

Remove the battery cover, battery, SIM, antenna cover, and rear housing as

described in the procedures

FRONT HOUSING

Figure 10. Removing the Vibrator and Vibrator Grommet

Turn the rear housing so the vibrator assembly is facing upward.

Using the flat end of the disassembly tool, carefully pry the vibrator assembly

from its cavity in the rear housing as shown in Figure 10. The assembly should

come away from the rear housing easily.

Separate the vibrator from the vibrator grommet.

To replace, insert the vibrator into the grommet. Ensure the vibrator shaft can

to rotate freely.

Align the vibrator assembly with the rear housing so the vibrator terminals

will contact the transceiver board contacts when reassembled, then press into

place until fully seated.

Replace the rear housing, antenna cover, SIM, battery, and battery cover as

described in the procedures.

October 14, 2002

VIBRATOR ASSEMBLY

Product Family C25

VIBRATOR GROMMET

VIBRATOR MOTOR

6881041B25

020584-o

Table of Contents

C300