Installing An Expansion Card To Riser Bracket 4 - Asus RS720A-E12 Series User Manual

2.7.5

Installing an expansion card to riser bracket 4

The pre-installed riser card bracket 4 (butterfly riser bracket) supports Low Profile (LP), Half-
Length (HL) PCIe x16 expansion cards.
To install a PCIe x16 (Gen5 x16 link) expansion card on the butterfly riser card bracket:
1. Remove the riser card brackets on the top section. You may refer to the following
sections depending on the system model:
For Standard model:
Please refer to steps 1 and 2 of Installing an expansion card to riser card bracket 1
(for standard model), and Installing an expansion card to riser card bracket 2 and
3 (for standard model) sections.
For GPU model:
Please refer to steps 1 and 2 of Installing an expansion card to riser card bracket 1
(for GPU model), and Installing an expansion card to riser card bracket 2 and 3 (for
GPU model) sections.
2. Lift the riser card out of the chassis by firmly holding it by the tab and pulling it upwards
to detach it from the PCIe slot on the motherboard.
ASUS RS720-E12 Series
2-39