4.
Connect the Cache Vault Power Module to the S-CAP connector on the PIKE II card or
HBA/RAID card.
5.
Follow steps 8 and 9 of the Installing an expansion card to riser card bracket 1 (for
standard model) section to install riser bracket 1 to the chassis.
To install the cache vault power module to riser bracket 4:
1.
Follow steps 1-3 of Installing an expansion card to riser bracket 4 to remove riser
card bracket 4 from the chassis.
2.
Align the three screw holes on the Cache Vault Power Module clip with the three screw
holes on the riser bracket, then secure the clip with the three bundled screws and hex
nuts.
3.
Align and install the Cache Vault Power Module into the Cache Vault Power Module
clip.
ASUS RS720-E12 Series
2-45