Network Stack Configuration - Asus RS720A-E12 Series User Manual

Device power-up delay [Auto]
Maximum time the device will take before it properly reports itself to the Host Controller.
[Auto] Uses default value; for a Root port it is 100 ms, for a Hub port the delay is
taken from Hub descriptor.
[Manual] Manually set the device power-up delay.
The following item appears only when Device power-up delay is set to [Manual].
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds. Use the <+> or <-> to adjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM]
5.4.9

Network Stack Configuration

Network stack [Enabled]
Enables or disables the network stack feature.
Configuration options: [Disabled] [Enabled]
The following item appears only when Network stack is set to [Enabled].
Ipv4 PXE Support [Disabled]
Enables or disables the Ipv4 PXE Boot Support. If disabled, Ipv4 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]
Ipv4 HTTP Support [Disabled]
Enables or disables the Ipv4 HTTP Boot Support. If disabled, Ipv4 HTTP boot option
will not be created.
Configuration options: [Disabled] [Enabled]
Ipv6 PXE Support [Disabled]
Enables or disables the Ipv6 PXE Boot Support. If disabled, Ipv6 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]
ASUS RS720A-E12 Series 5-31