Table of Contents
Advertisement
Figure 30. Installing the expansion card riser 1
Next steps
Follow the procedure listed in
Removing the expansion card riser 2
Prerequisites
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
NOTE:
The expansion card riser 2 cannot be removed without first removing the expansion card riser 1.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove expansion card riser
Steps
1. Using Phillips 1 screwdriver, remove the screws that secure the expansion card riser 2.
2. Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.
After working inside your
Safety
instructions.
Before working inside your
1.
system.
system.
Installing and removing system components
61
Advertisement
Table of Contents
