Sony Handycam DCR-VX2000 Operating Instructions Manual page 150

Troubleshooting
Symptom
The photo save function
does not work.
Others
Symptom
The title is not recorded.
The cassette label is not
recorded.
While editing using the
i.LINK cable (DV connecting
cable), recording picture
cannot be monitored.
Digital program editing
does not function.
150
Cause and/or Corrective Actions
•The write-protect tab on the "Memory Stick" is set to LOCK.
c Set the tab to write. (p. 115)
•The battery pack is dead.
c Install a charged battery pack or use the AC power
adaptor instead of the battery pack. (p. 9, 13)
Cause and/or Corrective Actions
•The tape has no cassette memory.
c Use a tape with cassette memory. (p. 97, 143)
•The cassette memory is full.
c Erase unnecessary title. (p. 100)
•The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 14)
•Nothing is recorded in that position on the tape.
c Superimpose the title to the recorded position. (p. 97)
•The tape has no cassette memory.
c Use a tape with cassette memory. (p. 103, 143)
•The cassette memory is full.
c Erase some data. (p. 105)
•The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 14)
c Disconnect the i.LINK cable (DV connecting cable), and
connect it again. (p. 74)
•The input selector on the VCR is not set correctly.
c Check the connection and set up the selector position.
(p. 73)
•The camcorder is not connected to Sony DV equipment.
c Set CONTROL to IR in the menu settings and set the
recording VCR to be controlled by infrared rays.
•Setting program on a blank portion of the tape is attempted.
c Set the program again on a recorded portion. (p. 84)
•Your camcorder and the VCR are not synchronized.
c Synchronize them. (p. 81)