Installation; Set Up And Operation - DAPAudio EVO 8 A Manual

EVO 8A

Installation

Remove all packing materials from the EVO 8A. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Fig. 03
01) Connect the active speaker to the passive speaker, by means of the included speaker cable.
02) Connect your mixer to the RCA line input connector (11) or to the line connector (10).
03) Connect power supply to the mixer.
04) Connect power supply to the active speaker, using the included C8 to Schuko power cable.
Order code: D3693
7