Figure 11. Inside the system
1. Drive cage
3. IDSDM card
5. Mezzanine card (fabric C)
7. Network Daughter Card (NDC)
9. Heat sink (CPU1)
11. Memory module (16)
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in
2. Turn off the system.
3.
Remove the system from the
4. Install the I/O connector cover.
Steps
1. Press the release button, and slide the cover toward the back of the system.
2. Lift the cover away from the system.
Safety instructions
on page 46.
enclosure.
2. Drive backplane
4. Air shroud
6. I/O connector cover
8. Mezzanine card (fabric B)
10. Heat sink (CPU2)
12. System handle
Installing and removing system components
51