Dell HHB006 Installation And Service Manual page 34

Viewing Network Settings
To view the Network Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
UEFI PXE Settings
Options
PXE Device n (n =
1 to 4)
UEFI HTTP
Options
Settings
HTTP Device (n =
1 to 4)
UEFI iSCSI Enables you to control the configuration of the iSCSI device.
Settings
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
Steps
1. Power on, or restart your system.
34 Pre-operating system management applications
Description
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the
device.
Description
Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the
device.
Table 23. UEFI iSCSI Settings screen details
Option
iSCSI Initiator Name
iSCSI Device1
iSCSI Device1 Settings
Description
Specifies the name of the iSCSI initiator in IQN
format.
Enables or disables the iSCSI device. When disabled,
a UEFI boot option is created for the iSCSI device
automatically. This is set to Disabled by default.
Enables you to control the configuration of the iSCSI
device.