Table of Contents
Advertisement
Operation Manual
1. Glue Dipping Pulley
2. Glue Transfer Pulley
3. Gluing Pulley
4. Gluing Rubber Board
5.4.2.9. Operation of Bottom Inserting Part
Adjustment of the first slotting tool: turn the large hub until the opening mouth of first clamp is on
the connecting line between the slotting tool shaft and the central shaft of large hub. Then loosen
the locking screw on the supporting arm of the first slotting tool, and turn the first slotting tool until
the cutter on the first slotting tool is inserted into the opening mouth of first clamp. Finally lock the
screw to avoid loosing.
The adjusting method for the second slotting tool is same as above. Usually it is unnecessary to
adjust the first slotting tool again after it has been adjusted properly (when the position does not
change), while the second slotting tool should be adjusted according to the position of second
clamp.
The insertion depth of the first slotting tool usually is approximately 12mm; the width should be
adjusted according to paper bag body width and usually is 6mm shorter than the bag body width;
and the two corners of the first slotting tool should be rounding.
The insertion depth of the second slotting tool is about 13mm and the width should be larger than
paper bag width. It is appropriate to use the standard slotting tool equipped with the machine and it
is unnecessary to adjust it any more.
—————Jiangsu Fangbang Machinery Co., Ltd.—————
Figure 26. Schematic Diagram of Bottom Gluing Part
ZD-FJ08C
29
Advertisement
Table of Contents
