Table of Contents
Advertisement
Operation Manual
1. Fastening Screw of Forming Mould
2. Locking Screw of Upper Crossbeam
3. Adjusting Screw of Upper Crossbeam
4. Lower Forming Mould
5. Material Traction Pulley
Angle Adjustment of Forming Moulds: loosen the locking screws on upper crossbeam of machine
frame (Figure 9-2), and adjust the adjusting screw on the inner side of crossbeam, so that the
included angle of two forming moulds can be adjusted. The adjusting principle is: adjust the lower
forming mould until its plane is tangent to material traction pulley.
—————Jiangsu Fangbang Machinery Co., Ltd.—————
Figure 9. Side View of Tube Forming Component
ZD-FJ08C
15
Advertisement
Table of Contents
