Table of Contents
Advertisement
Operating the appliance
en
Calibrating the appliance and cleaning the cooking
compartment
Notes
Calibration cannot be started until the cooking
■
compartment is cold (room temperature).
Do not open the appliance door while calibration is
■
in progress, as this will abort the calibration process.
Press the on/off button to switch on the appliance.
1.
Fill the water tank. ~ "Filling the water tank"
2.
on page 19
Set the specified type of heating, temperature and
3.
duration for the calibration, then start the appliance.
~ "FullSteam – Steam cooking" on page 18
Calibration
Type of heating
Temperature
Cooking time
Heat up the appliance following calibration.
4.
Caution!
Enamel damage
Do not use the appliance if there is water on the
cooking compartment floor. Before using the
appliance, wipe away the water from the cooking
compartment floor.
Dry the cooking compartment floor.
5.
Set the specified type of heating and temperature for
6.
heating, then start the appliance.
Heating up
Type of heating
Temperature
Cooking time
Keep the kitchen ventilated while the appliance is
7.
heating.
Stop the appliance once the specified time has
8.
elapsed. Press the on/off button to switch off the
appliance.
Wait for the cooking compartment to cool down.
9.
Clean the smooth surfaces with soapy water and a
10.
dish cloth.
Empty the water tank and dry the cooking
11.
compartment. ~ "After every steam operation"
on page 20
Notes
When relocating the appliance, restore its factory
■
settings once it is installed so that it can adapt to its
new location. Repeat the procedures for initial start-
up and calibration.
The appliance retains the calibration settings, even
■
in the event of a power cut or disconnection from the
mains. Calibration does not need to be repeated.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
16
Steam P
100 °C
30 minutes
4D hot air :
Maximum
30 minutes
1Operating the appliance
Y ou have already learnt about the controls and how
O p e r a t i n g t h e a p p l i a n c e
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Switching the appliance on and off
Before you are able to set the appliance, you must
switch it on.
Exception: The childproof lock and the timer can be set
when the appliance is switched off.
Displays or information, e.g the residual heat indicator
in the cooking compartment, remain visible in the
display after the appliance has been switched off.
Switch off your appliance when you do not need to use
it. If no settings are applied for a long time, the
appliance switches itself off automatically.
Switching the appliance on
Use the On/Off button to switch the appliance on.
The on/off symbol above the button is illuminated in
blue.
The Siemens logo appears in the display, and then a
type of heating and a temperature.
You can specify which operating modes should
Note:
appear after the appliance is switched on in the basic
settings.
Switching off the appliance
Use the On/Off button to switch off the appliance.
The lighting above the button goes out.
A set function is cancelled.
The time appears in the display.
You can set whether or not the time should be
Note:
displayed when the appliance is switched off in the
basic settings.
Starting or interrupting operation
To start operation or to interrupt an operation which has
started running, press the Start/Stop button. The
cooling fan may continue to run after an operation is
interrupted.
Press the On/Off button to delete all settings.
If you open the cooking compartment door during
operation, operation is interrupted. Close the cooking
compartment door to continue operation.
Advertisement
Table of Contents
