Table of Contents
Advertisement
The following table explains the indications in the parameter setting mode.
Operation panel indication
4.1.3
Digital characters and their corresponding printed
equivalents
Digital characters displayed on the operation panel display are as follows.
0
E(e)
Q(q)
4.1.4
Changing the parameter setting value
The following shows the procedure to change the setting of Pr.774 Operation panel monitor selection 1.
Operating procedure
1.
Turning ON the power of the converter unit
The operation panel is in the monitor mode.
2.
Selecting the parameter setting mode
Press
3.
Selecting the parameter
Turn
until "
"
" (initial value) appears.
76
4. BASIC OPERATION
4.1 Operation panel
Function name
Parameter setting mode
Parameter clear
All parameter clear
Fault history clear
Parameter copy
Initial value change list
Group parameter setting Displays parameter numbers by function groups.
1
2
3
4
5
F(f)
G(g)
H
h
I(i) J(j) K(k) L(l) M(m) N
R
r
S(s) T(t)
U
to choose the parameter setting mode. (The parameter number read previously appears.)
" (Pr.774) appears. Press
Under this mode, the set value of the displayed parameter number is read
or changed.
Clears and resets parameter settings to the initial values. However,
parameters such as terminal function selection parameters are not
cleared. For the details of the uncleared parameters, refer to
Clears and resets parameter settings to the initial values. Terminal
function selection parameters are also cleared. For the details of the
uncleared parameters, refer to
Deletes the fault history.
Copies the parameter settings saved in the converter unit to the operation
panel. The parameters copied to the operation panel can be also copied
to other converter units.
Identifies the parameters that have been changed from their initial
settings.
6
7
8
9
A B(b) C
u
V
v
W
w X(x) Y(y) Z(z)
to read the present set value.
Description
page
182.
c D(d)
n
O
o P(p)
Refer
to
page
76
143
page
182.
143
152
144
147
83
Advertisement
Table of Contents
