Mitsubishi Electric FR-CC2-H315K Instruction Manual page 34

NOTE
• To prevent a malfunction due to noise, keep the signal cables 10 cm or more away from the power cables. Also, keep the
cables of the main circuit for input and output separated.
• After wiring, do not leave wire offcuts in the inverter or the converter unit.
Wire offcuts can cause a fault, failure, or malfunction. Always keep the inverter and the converter unit clean.
When drilling mounting holes in an enclosure etc., take caution not to allow chips and other foreign matter to enter the inverter
or the converter unit.
• The terminal connection diagram shows the wiring for 6-phase rectification. For 12-phase rectification, refer to
wiring to the main circuit terminals.
page 41
2. INSTALLATION AND WIRING
2.4 Terminal connection diagrams
1
2
for
3
4
5
6
7
8
9
10
33