Configure - Emerson Fisher 4320 Instruction Manual

Instruction Manual
Field Trial Release
February 2009
Field Communicator
1 Offline
2 Online
3 Frequency Device
4 Utility
Online
1 Overview
2

Configure

2 Configure
1 Manual Setup
3 Service Tools
2 Cycle Counter Alert Setup
2-2
Cycle Counter Alert Setup
1 Alert Trigger
2 Accumulated Cycles
3 Reset Cycle Counter
D Model— indicates the device type.
D HART Universal Rev.— indicates the HART
Universal Revision.
D Device Revision— the revision number of the
software for communication between the Field
Communicator and the instrument.
D Firmware Revision— the revision number of the
firmware in the instrument.
D Hardware Revision— the revision number of
the electrical circuitry within the instrument printed
wiring board.
D DD Revision— indicates the revision level of
the device description.
D Radio Information
Manufacturer— identifies the manufacturer of the
radio.
Manual Setup
1 Device Identification
2 Wireless
3 Burst Mode
2-1
4 Broadcast Power
5 Power Information
6 Trigger Points
Figure 11. 375 Menu Tree—Configure
4320 Wireless Position Monitor
Device Identification
2-1-1
1 HART Tag
2 HART Long Tag
3 Descriptor
4 Message
2-1-3
Burst Mode
1 Burst Mode
2
3 Update Period.
4 Change Update Pe...
5 Change Burst Com...
6 Burst Mode Setup
2-1-3-6
2-1-4 Broadcast Power
1 Power Level
2-1-5
Power Information
1 Power Source
2 Power Module Type
Trigger Points
2-1-6
1 Percent of Span
2 Open Trigger Point
3 Closed Trigger Point
4 Deadband (5%)
5 Change Trigger Pts
Model— indicates the radio model.
Device Revision— indicates the revision level of the
radio.
Hardware Revision— indicates the revision level of
the radio hardware.
Firmware Revision— indicates the revision level of
the radio firmware.
Configure
Refer to figure 11 for the Configure menu tree.
Manual Setup
D Device Identification
HART Tag—Enter an up to 8 character HART tag for
the instrument. The HART tag is the easiest way to
distinguish between instruments in a
multi-instrument environment. Use the HART tag to
label instruments electronically according to the
Wireless
2-1-2
1 Network ID
2 Set Net ID & Join Key
1 Command 1
2-1-3-5
2 Command 3
3 Command 48
4 Help
Burst Mode Setup
1 Disable Burst Mode and Exit
2 Reconfigure Burst Mode
3 Exit Without Making Changes
11