Lenovo 7D96 Manual page 178

a. Disable Secure Boot: assert Physical Presence and then change Secure Boot Setting to Disable (
in F1 Setup -> System Settings -> Security -> Security Boot Configuration -> Security Boot
Setting).
b. Enroll the unauthorized UEFI Image. assert the Physical Presence and then change Secure Boot
Policy to Custom Policy ( in Setup -> System Settings -> Security -> Security Boot Configuration
-> Security Boot Policy), then enter into "Security Boot Custom Policy" Menu, press the "Enroll Efi
Image" button, select the unauthorized UEFI Image in the popup box. (NOTE: There're two ways
to assert Physical Presence. 1) switch Physical Presence Jumper to ON ; 2) If the Physical
Presence Policy has been set to enabled ( F1 Setup -> System Settings -> Security -> Physical
Presence Policy Configuration), user is allowed to assert remote Physical Presence via IPMI tool.)
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
• FQXSFPU0023I: Secure Boot Image Verification Failure has been cleared as no failure in this round
boot.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU0027N: System uncorrectable error has occurred on Processor [arg1] Core [arg2] MC
bank [arg3] with MC Status [arg4], MC Address [arg5], and MC Misc [arg6].
Severity: Fatal
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem returns Collect Service Data log.
3. Contact Lenovo Support.
• FQXSFPU0030N: A firmware fault has been detected in the UEFI image.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. If problem persists, save customer's UEFI configurations, then remove and re-install CMOS battery
for 30 seconds to clear CMOS contents. If it boots successfully, then restore system settings.
5. If the problem persists, collect Service Data logs.
6. Contact Lenovo Support.
• FQXSFPU0031N: The number of POST attempts has reached the value configured in F1 setup.The
system has booted with default UEFI settings. User specified settings have been preserved and will
be used on subsequent boots unless modified before rebooting.
Severity: Error
User Action:
174
ThinkSystem SR850 V3 Messages and Codes Reference