Lenovo 7D96 Manual page 136

Complete the following steps:
1. Check the Lenovo support site for an applicable service bulletin or firmware update that applies to
this error.
2. Reboot the system.
3. If the error continues, replace the system-board assembly (see hardware maintenance manual).
• FQXSPUN0026I: Device [LogicalDeviceElementName] has been added.
This message is for the use case when an implementation has detected a Device was inserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0536
User Action:
Information only; no action is required
• FQXSPUN0048I: The RAID controller in PCI slot [arg1] in optimal status.
This message is for the use case when an implementation has detected a Sensor transition to the normal
state.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0518
User Action:
Information only; no action is required
• FQXSPUN2009I: Sensor [SensorElementName] has deasserted.
This message is for the use case when an implementation has detected a Sensor has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0509
User Action:
Information only; no action is required
• FQXSPUN2012I: Sensor [SensorElementName] has deasserted.
This message is for the use case when an implementation has detected a Sensor has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
132
ThinkSystem SR850 V3 Messages and Codes Reference