Lenovo 7D96 Manual page 15

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPEM4033I Acoustic Mode [arg1] has been disengaged to allow adequate
cooling.
FQXSPFC4000I The bare metal connection process has been started.
FQXSPFC4001I The bare metal update application reports a status of [arg1].
FQXSPFC4002I System running in setup.
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot.
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc.
FQXSPFC4005I UEFI deployment boot mode has been disabled.
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
FQXSPIO0000I The connector [PhysicalConnectorElementName] has been
connected.
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName].
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
FQXSPIO2004I Bus [SensorElementName] has recovered from a bus timeout.
FQXSPIO2006I System [ComputerSystemElementName] has recovered from an NMI.
FQXSPIO2007I A PCI PERR recovery has occurred on system
[ComputerSystemElementName].
FQXSPIO2008I A PCI SERR on system [ComputerSystemElementName] has
deasserted.
FQXSPIO2010I Bus [SensorElementName] has recovered from a Correctable Bus
Error.
FQXSPIO2014I Bus [SensorElementName] is no longer operating in a degraded state.
FQXSPIO4002I GPU Board Status was recovered by [arg1] of [arg1].
FQXSPMA0009I Memory sparing initiated for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
FQXSPMA2007I Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] has recovered.
FQXSPMA2010I [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] is no longer Throttled.
FQXSPMA2012I An Over-Temperature Condition has been removed on the
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
FQXSPMA2024I Sensor [SensorElementName] has deasserted.
FQXSPNM4000I Management Controller [arg1] Network Initialization Complete.
FQXSPNM4001I Ethernet Data Rate modified from [arg1] to [arg2] by user [arg3].
FQXSPNM4002I Ethernet Duplex setting modified from [arg1] to [arg2] by user [arg3].
FQXSPNM4003I Ethernet MTU setting modified from [arg1] to [arg2] by user [arg3].
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
.
Chapter 2 XClarity Controller events
11