Front Runner JADA014 Manual

Hi-lift jack bracket top mount

Download this manual

ENG

front runner

hi-lift jack bracket top mount

JADA014

READ ME !

Thank you for purchasing a Front Runner Hi-Lift Jack Bracket Top Mount.

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the included components.

Refer to Page 2 for a list of all the components, quantities and tools required.

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD

RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT

RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND

DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO

INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY

FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please call us if you have any questions about the installation of this product.

JADA014_REV_A00

Page 1 FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL. NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Page 2 M8 Nyloc Nut M8 Plastic Nut Cap M10 Flat Washer M8 x 20mm Hex Head Bolt M8 x 16 x 1.6 Flat Washer Mounting Key M10 Spring Washer M10 Wing Nut FIGURE 1.1 FIGURE 1.2 JADA014_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 3 M8 Threaded Rod (Item 3) and orientation of the Clamp Bracket (Item In the orientation seen in Fig 2.3, please note the position of the M8 Threaded Rod (Item 3) and orientation of the Clamp Bracket (Item JADA014_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 4 M8 Thin Nut (Item 4), securing the mounting brackets. Place the M8 Nut Caps (Item 9) onto the M8 Nyloc Nuts (Item 8). Tightening Torque: M8 : 15-20Nm / 11.06 ft lb - 14.75 ft lb JADA014_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 5 Congratulations! You did it. Take a step back and admire your work! INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner Dealer in person or online. Be sure to tag us. We love to see our gear in action! #FrontRunnerOutfitters #BornToRoam...