Front Runner FAMG001 Instructions Manual

Front Runner FAMG001 Instructions Manual

Mercedes benz g-class (2019- current) foot rails

Advertisement

front runner
START HERE!
Don't be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain
aspects of your warranty.
Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components.
A complete kit will contain:
1. A Front Runner Mounting System specific to your vehicle
2. A Front Runner Rack Tray or Load Bar Slats
This document will guide you through the assembly of the mounting system and assist you in fitting the roof rack tray or load bars to your specific
vehicle.
Please refer to the next page for a list of all the components, quantities and tools required.
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
FAMG001_REV_A00
Mercedes Benz G-Class (2019- current)
Foot Rails
READ ME FIRST
IMPORTANT WARNING!
Please call us if you have any questions about the installation of this product.
1
FAMG001
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
ENG

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FAMG001 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Front Runner FAMG001

  • Page 1 Don’t be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain aspects of your warranty. Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components. A complete kit will contain: 1.
  • Page 2 12 X M5 Nut Cap 12 X M5 Nyloc Nut 12 X M5 x 13 x 1SS Flat Washer Mounting Foot Base T - Bolt Foam Gasket 12 X Spacer Assembly FIGURE 1.1 FAMG001_REV_A00 © 2019 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 3 Spacers (Item 18), M5 x 13 x 1SS Flat Washer and M5 Nyloc Nuts (Items 13 & 14) as shown. Fully tighten and place a M6 Nut Cap (Item 12) over each of the Nyloc Nuts. FAMG001_REV_A00 © 2019 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 4 Nyloc Nuts (Items 5 & 6) as shown. 10mm Make sure the T Bolt remains in the correct orientation while tightening. See detail A in 2.5. Place a M6 Nut Cap over each of the Nyloc Nuts. FAMG001_REV_A00 © 2019 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 5 M8 x 20 Hex Bolts, M8 x 16 x 1.6SS Flat Washers and M8 Nyloc Nuts (Items 8, 9 & 10). 13mm Center the rack and tighten fully. Use M8 nut caps (Item 11) to finish off the nuts. FAMG001_REV_A00 © 2019 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 6 IMPORTANT! FRONT RUNNER RACK KITS OFTEN HAVE A HIGHER LOAD RATING THAN THE VEHICLES THEY ARE MOUNTED TO. PLEASE REFER TO YOUR SPECIFIC VEHICLE MANUFACTURER FOR A RECOMMENDED ROOF RATING. FRONT RUNNER CANNOT BE RESPONSIBLE FOR IMPROPER LOADING BEYOND THE VEHICLE MANUFACTURER'S STATED LOAD CAPACITY.

Table of Contents