Table of Contents
Advertisement
Connecting the drain hose:
1. Remove the black hose from the connection at the back of the dryer (A).
2. Uncoil the drain hose (included with your dryer) and connect it to the black hose (B).
3. Place the other end of the drain hose into a tub or standpipe.
If you connect the drain hose onto your dryer, the other end must be secured in a drain to prevent
water draining onto the floor. Ensure the drain hose is securely fixed in place to an appropriate drain
and is leak-free at the connection to the machine. Check the connection and drain hose regularly.
• Maximum standpipe height is 1m from ground level.
• Regularly check that your standpipe or tub is free from lint and other obstructions, which may affect drainage
and cause flooding.
• The drain hose should be checked from time to time and replaced if any damage, eg wear, cuts, bulges, kinks,
leaks, etc are found. Do not bend the drain hose sharply, as this may cause it to split.
• The extended length of the provided drain hose is 1.3m.
• In multi-storey apartments or any upper floor, the machine should be installed on a floor equipped with a drain.
• Draining must comply with local by-laws.
Electrical Connection
1. This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, 10A electrical supply.
2. Uncoil the power cord, remove and discard the plastic pin cover and plug into a power socket.
3. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
• Check the power cord for damage and make sure it is not squashed or twisted when installing the dryer.
• Always remove the power cord from the power socket by the plug, not by the cord.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Heat_Pump/DH8060C1/User_Guide_DH8060C1/03_Installation_Instructio...
Updated: Sun, 25 Jun 2023 12:59:32 GMT
Powered by
4
Advertisement
Table of Contents
