Advertisement
Draining
The dryer is equipped with a condenser unit which accumulates water during the drying
cycle. This water is collected in the removable water tank located at the top left of the
dryer. The accumulated water must be emptied after each drying cycle. However you
can also set up your dryer to drain automatically using the drain hose provided.
Connecting the drain hose:
1. Remove the black drain hose from the connection at the back of the dryer (A)
and place it on the other connection to the left (B). Uncoil the white drain hose
and connect it to the back of the dryer where the black drain hose was
previously connected (C).
2. Place the other end of the white drain hose into a tub or standpipe. The
connection between the dryer and the white drain hose (C) must be secured to
avoid a potential flood.
If you connect the white drain hose onto your dryer and you do not secure the other end in a drain,
your dryer will drain water onto your floor. Ensure the drain hose is securely fixed in place to an
appropriate drain and is leak-free at the connection to the machine.
• Regularly check that your standpipe or tub is free from lint and other obstructions, which may affect
drainage and cause flooding.
• The drain hose should be checked from time to time and replaced if any damage, eg wear, cuts, bulges,
kinks, leaks, etc are found. Do not bend the drain hose sharply, as this may cause it to split.
• The extended length of the provided drain hose is 1.3m.
• In multi-storey apartments or any upper floor, the machine should be installed on a floor equipped with a
drain.
• Draining must comply with local by-laws.
Electrical Connection
1. This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, 10A electrical supply.
2. Uncoil the power cord, remove and discard the plastic pin cover and plug into a power socket.
3. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
• Check the power cord for damage and make sure it is not squashed or twisted when installing the dryer.
• Always remove the power cord from the power socket by the plug, not by the cord.
https://producthelp.fisherpaykel.com/nz/Dry/Dryers/Condensing/DC8060P1/User_Guide_DC8060P1/03_Installation_Instructions
Installing the drain hose
Updated: Thu, 20 Jul 2023 18:15:05 GMT
Powered by
4
Advertisement
