Electrical Connection
1. This appliance must be connected to a 220V – 240V, 50Hz,
sinusoidal, 10A electrical supply.
2. Uncoil the power cord, remove and discard the plastic pin cover and
plug into a power socket.
3. Connect the appliance to an earthed outlet protected by a fuse of
suitable capacity.
• Check the power cord for damage and make sure it is not squashed
or twisted when installing the dryer.
• Always remove the power cord from the power socket by the plug,
not by the cord.
• Do not touch or operate the dryer with wet hands or with bare feet.
• A damaged power cord must be replaced by a Fisher & Paykel trained and supported service
• Do not operate this dryer if it has been damaged during transport. Contact your Fisher & Paykel
The appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by a utility.
Completing the Installation
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Vented/DE4560M1/User_Guide_DE4560M1/03_Installation_Instructions
technician. The appliance must not be operated until it is repaired, as there is risk of electric
shock.
dealer or Fisher & Paykel trained and supported service technician.
External venting with kit part
number PD-SVHCW4
Updated: Thu, 27 Jan 2022 05:02:50 GMT
Powered by
9