Table of Contents
Advertisement
Attention
Une tension continue peut être présente sur les broches RJ-45 4, 5 (+) et 7, 8 (-).
Note
This is not a mid-span powered device. Never attempt to daisy-chain Power Over Ethernet devices.
Connecting the Ethernet cable through the watertight gland
Use the following procedure to connect an Ethernet cable and RJ-45 connector to either the LAN
or MGT port. Use the pin assignments in
Have the Ethernet data cable, nut, rubber boots, and cable gland available.
1.
Remove the cable gland from the bottom of the router. Determine the port to use (see
2.
Figure
3.
Press the tab on the RJ-45 connector down as you push the cable through the nut. Make sure
that the orientation is consistent with
Separate the rubber boot as needed and slide the connector through the boot. Use the boot
4.
with the smaller diameter opening, unless the cable is too wide to permit the boot to close
completely.
Slide the cable through the cable gland, as shown in
5.
FIGURE 14
Rubber boot
Nut
Tropos 6410-XA and 6420-XA Installation Guide
15).
Routing the Data/Power Cable to the Router
Cable gland
Table
3.
Figure
14.
Figure
14.
Chapter 2
33
Advertisement
Table of Contents
