Table of Contents
Advertisement
Mount the Tropos router on a tower
Remove the pole bracket from the mounting bracket, if they are attached.
1.
Make a tower bracket by attaching the mounting bracket directly to any stainless steel or
2.
galvanized steel pipe.
Attach the mounting bracket to the tower arm so that the top of the shield is horizontal and
3.
level.
Tighten the mounting bolts.
4.
Place the upright router onto the top of the mounting bracket, as shown in
5.
23. Secure the mounting bracket to the router by attaching two 5/16-inch machine screws
through the holes in the mounting bracket tabs to corresponding holes on the bottom of the
router.
To continue installing the router, see
Tropos 6410-XA and 6420-XA Installation Guide
"Connecting Data and Power Cables"
Chapter 2
Figure 5
on page
on page 32.
27
Advertisement
Table of Contents
