Figure 10 Routing The Data/Power Cable To The Router; Figure 11 Data Port Connection - ABB Tropos 6410 Installation Manual

FIGURE 10
Rubber boot
Nut
6. Plug the cable into the appropriate port on the router.
7. Screw the cable gland onto the bottom of the router, and then slide the nut over the rubber
boot and screw both tightly to the cable gland. Tighten the nut to ensure a positive water
seal.
FIGURE 11
MGT port
LAN port
(includes power)
Shielded outdoor
Tropos Routers Installation Guide, Models 6410 and 6420
Routing the Data/Power Cable to the Router
Cable gland
Figure 11 shows how the cable assembly is attached to the bottom of the router.
Data Port Connection
cat5 cable
drip loop
Shield termination
Cable gland
(watertight)
Access area
Tighten two screws to
fasten cable gland
Chapter 2
31