Table of Contents
Advertisement
Connecting Data and Power Cables
The router is equipped with two RJ-45 ports.
LAN. The port labeled LAN is a 10/100/1000BASE-T Ethernet port normally used for a
network backhaul connection. The router can be powered over this port using industry-
standard 802.3at PoE (Power over Ethernet) power (do not use any other form of PoE power
on this port). This port can also be used to configure the router.
MGT. The port labeled MGT is one of two types, depending on the specific Tropos 6410-
XA or 6420-XA model. See the model number descriptions in
Product Summary"
12. If you have any questions about models or configuration, contact Tropos Customer
Support (tropos.support@nam.abb.com).
— On some models the MGT port is a 10/100/1000BASE-T Ethernet port used for
— On some models the MGT port is a serial port that is capable of supporting RS-232 or
The router can be powered over the MGT port using DC power in the range 12-48VDC (see
pin assignments on the RJ-45 connector in
This section describes how to connect the Ethernet cables.
Note
The router is shipped pre-configured. For post-installation changes in configuration, you can communicate
with the router by way of its wireless connection. For more information, see the Tropos Networks User
Guide.
Note
Only use shielded Cat5, Cat5e, or Cat6 cable rated for outdoor use. For protection against risk of fire,
electrical hazard and to ensure the reliable operation of this equipment, the shields of the Cat5 cable must
be properly terminated and bonded to the unit and to the protective earth (PE) at the building entrance.
Note
National Electrical Codes (NEC) Article 800 requires the use of Agency Listed (UL/CSA) Building Entrance
Protector for all power and communications cables entering a building. The NEC intends by Article 800 to
protect the building and occupants from fires caused by transient voltage and current surges.
Warning
DC voltage may be present on RJ-45 pins 4,5 (+) and 7,8 (-).
Tropos 6410-XA and 6420-XA Installation Guide
on page 11 and
configuration and for connecting a wired Ethernet client to the router.
RS-485 serial clients.
"Tropos 6420-XA Router Product Summary"
Table
3).
Chapter 2
"Tropos 6410-XA Router
on page
32
Advertisement
Table of Contents
