Table of Contents
Advertisement
Mount the router on a metal pole
Select a mounting location. You can attach the router to any pipe or pole with diameter
1.
between 1 inch and 10 inches.
Slip the flat portion of each clamp under the inner slot of the pole bracket.
2.
Use the clamps to attach the pole bracket to the pole, making sure that they are level.
3.
Depending upon the diameter of the pole, you may need to use small clamps, large clamps,
or pairs of large clamps joined together to reach around the pole.
4.
Attach the mounting bracket of the router to the pole bracket with two 5/16-inch machine
screws (refer to
— Insert one screw through the hole at the top of the mounting bracket to the hole at the top
— Insert the other screw through the curved slot track in the mounting bracket to the hole in
5.
Level the mounting bracket by rotating the unit along the curved slot tracks. Tighten the
screws.
Place the upright router onto the top of the mounting bracket, as shown in
6.
the mounting bracket to the router by attaching two 5/16-inch machine screws through the
holes in the mounting bracket tabs to corresponding holes on the bottom of the router.
FIGURE 5
To continue installing the router, see
Tropos 6410-XA and 6420-XA Installation Guide
Figure 4
for the correct orientation):
of the pole bracket.
the middle of the pole bracket just above the clamp slots.
Placing the Router on the Mounting Assembly
"Connecting Data and Power Cables"
Chapter 2
Figure
5. Secure
on page 32.
23
Advertisement
Table of Contents
