Table of Contents
Advertisement
Attach the mounting bracket of the router to the pole bracket with two 5/16-inch machine
4.
screws (refer to
— Insert one screw through the hole at the top of the mounting bracket to the hole at the top
— Insert the other screw through the curved slot track in the mounting bracket to the hole in
Level the mounting bracket by rotating the unit along the curved slot tracks. Tighten the
5.
screws.
6.
Place the upright router onto the top of the mounting bracket, as shown in
23. Secure the mounting bracket to the router by attaching two 5/16-inch machine screws
through the holes in the mounting bracket tabs to corresponding holes on the bottom of the
router.
To continue installing the router, see the next section,
Connecting Data and Power Cables
The router is equipped with two RJ45 ports.
LAN. The port labeled LAN is a 10/100/1000Base-T Ethernet port normally used for a
network backhaul connection. The router can be powered over this port using industry-
standard 802.3at PoE (Power over Ethernet) power (do not use any other form of PoE power
on this port). This port can also be used to configure the router.
MGT. The port labeled MGT is one of two types, depending on the specific Tropos 6410 or
6420 model. See the model number descriptions in
on page 11 and
questions about models or configuration, contact Tropos Customer Support
(tropos.support@nam.abb.com).
— On some models the MGT port is a 10/100/1000Base-T Ethernet port used for
— On some models the MGT port is a serial port that is capable of supporting RS-232 or
The router can be powered over the MGT port using DC power in the range 11-55VDC (see
pin assignments on the RJ-45 connector in
This section describes how to connect the Ethernet cables.
Note
The router is shipped pre-configured. For post-installation changes in configuration, you can communicate
with the router by way of its wireless connection. For more information, see the Tropos Networks User
Guide.
Tropos Routers Installation Guide, Models 6410 and 6420
Figure 4
for the correct orientation):
of the pole bracket.
the middle of the pole bracket just above the clamp slot.
"Tropos 6420 Router Product Summary"
configuration and for connecting a wired Ethernet client to the router.
RS-485 serial clients.
"Connecting Data and Power Cables."
"Tropos 6410 Router Product Summary"
on page 12. If you have any
Table
3).
Chapter 2
Figure 5
on page
29
Hide quick links:
Advertisement
Table of Contents
