Adjust Carbonator Co2 Regulator And Turn Water Inlet Supply Line On; Unit Operation - Cornelius FlavorFusion Series Installation Manual

FlavorFusion Installation Manual
NOTE:See applicable Flow Diagram (see Figure 8 ) or Decal on the lower front of the unit for the location of
syrup and water connections.
6. Clean the hopper interior (see CLEANING INSTRUCTIONS in Owner's Manual).
7. Connect the unit power cord to a 120 volt, 60 cycle, 3-wire grounded receptacle. For 220-240 Volt Interna-
tional Units, a 3-wire power cord is provided. An adapter plug for the particular country will need to be pro-
vided by the Installer.
A C
DJUST ARBONATOR
L ON
INE
CAUTION: Before connecting the CO
adjusting screw to the left (counterclockwise) until all tension is relieved from the adjusting screw
spring.
1. Open (counterclockwise) CO
valve fully to back-seat the valve. (Back-seating the valve prevents leakage around the valve shaft).
2. The carbonator CO
3. Open one of the post-mix dispensing valves to exhaust trapped air inside the carbonator tank.
CAUTION: Never operate the carbonator pump with the water inlet supply line shutoff valve closed.
"Dry running" the water pump will burn out the pump. A pump damaged in this manner is not covered
by warranty.
4. Open the water inlet supply line shutoff valve.
U O
NIT PERATION
WARNING: The unit must be electrically grounded to avoid possible fatal electrical shock or serious
injury to the operator. The unit power cord is equipped with a three-prong plug. If a three-hole
(grounded) electrical outlet is not available, use an approved method to ground the unit.
Failure to ground the unit could result in serious Injury, Death or Damage to the Equipment.
1. Connect electrical power to the Unit.
2. Locate the switch on the junction box of the carbonator pump, and turn it ON. The water pump will start and
fill the carbonator tank with carbonated water. The water pump will stop when thecarbonator tank is full.
3. Check for water and CO
4. Dispense several drinks until the carbonator pump cycles on. The refill time should be about 5-7seconds.
5. If the carbonator pump appears to be short-cycling, meaning a refill time of 1-2 seconds, refer to the Trou-
bleshooting section.
Publication Number: 621057601INS
CO R
2 EGULATOR AND
regulator assembly to a CO
2
cylinder valve slightly to allow lines to slowly fill with gas, then open the
2
regulator is fixed at a nominal 75 psi.
2
leaks, and tighten any loose connections
2
T W
URN ATER
2
- 5 -
I S
NLET UPPLY
cylinder, turn the regulator
© 2005-2010, IMI Cornelius Inc.