Access The Command Line Interface - Patton SmartNode 4520 Series Quick Start Manual

4.0 Access the Command Line Interface

1. In the Discovery Tool window, select the IP address of your SmartNode.
2. Right-click the selected line, and select Telnet.
3. In the telnet window, enter the username administrator. At the password prompt
simply press the enter key. The SmartNode will respond by displaying its IP
address as the command line prompt.
4. After you log in your SmartNode will be running in operator execution mode
(indicated by > character in the command line prompt). To enter configuration
mode, use the commands enable and configure.
10.10.22.50>enable
10.10.22.50#configure
10.10.22.50(cfg)#
You may now start to configure the SmartNode from scratch using the CLI commands,
but we recommend that you start your configuration from a template. See section
"Download a configuration example, adapt it to your network, and load it onto the
SmartNode" on page 7 for further details.
For a detailed description of the CLI refer to the SmartWare Software Configuration
Guide (SCG) available online at www.patton.com/smartnode.
6 SmartNode 4520 & 4110 Quick Start Guide
5.0