Table of Contents
Advertisement
5.
Serial ATA 6.0Gb/s connector (7-pin SATA6G_1~2)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
EMB-APL3
EMB-APL3 SATA 6.0Gb/s connectors
6.
USB 2.0 connectors (10-pin USB2_56, HUB_USB2_P12, HUB_USB2_
P34)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
EMB-APL3
EMB-APL3 USB2.0 connectors
CAUTION! Never connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
NOTE: The USB module cable is purchased separately.
Chapter 2: Motherboard information
USB2_P56
HUB_USB2_P12
PIN 1
PIN 1
HUB_USB2_P34
PIN 1
2-13
Advertisement
Table of Contents
